Secondary Clarifier Superoxygenation to Increase Active Biomass and Stop Rising Sludge
Nota de aplicação da ECO₂ sobre a oxigenação de decantadores secundários para manter mais biomassa ativa e acabar com o lodo ascendente, sem aumentar o volume de tanques.
Detalhes
Resumo
Nota de aplicação sobre a dissolução de oxigênio puro no afluente de um decantador secundário, para que a manta de lodo continue aeróbia enquanto sedimenta. Um decantador secundário típico tem uma demanda de oxigênio dissolvido de cerca de 40 mg/L, e o oxigênio puro permite dissolver de 40 a 60 mg/L sem ultrapassar a saturação nem alterar a sedimentação.
Números-chave
40mg/L
Demanda típica de oxigênio dissolvido de um decantador secundário 40 a 60mg/L
OD que o oxigênio puro consegue dissolver no afluente do decantador sem ultrapassar a saturação 60mg/L
Saturação de OD com oxigênio puro a 15 ft de carga
Perguntas
O que faz a Superoxigenação do afluente do decantador secundário?
Mantém a manta de lodo aeróbia durante a sedimentação, o que aumenta os sólidos sob aeração, reduz a relação alimento/microrganismo (F:M), aumenta o tempo de retenção de sólidos (SRT), acrescenta remoção de DBO e evita o lodo ascendente causado pela desnitrificação. (PDF, página 1) (abre em nova aba)
De quanto oxigênio dissolvido um decantador secundário precisa?
A demanda depende do tempo de detenção hidráulica multiplicado pela taxa de consumo de oxigênio; decantadores secundários típicos têm demanda de OD de 40 mg/L. (PDF, página 1) (abre em nova aba)
Como se compara à estabilização por contato?
A ideia é parecida: dar às bactérias tempo para metabolizar a DBO armazenada antes do retorno, mas isso acontece dentro do decantador existente, sem volume adicional de tanque. (PDF, página 1) (abre em nova aba)
Na íntegra
Mais números-chave
Mais cinco, cada um com o que mede e sua página no PDF.
Do PDF
| Número | O que mede |
|---|---|
| 6.700 lb/MGD | Sólidos em condição aeróbia com um decantador óxico, contra 4.200 lb/MGD com um anóxico (Página 2 do PDF (abre em nova aba)) |
| 750 gpd/ft² | Taxa de aplicação superficial do decantador no exemplo da ECO₂ (Página 2 do PDF (abre em nova aba)) |
| 9.000 mg/L | Concentração do lodo de retorno no exemplo (Página 2 do PDF (abre em nova aba)) |
| 2.500 lb/MGD | Sólidos na manta de lodo de 5 ft do decantador, mantidos em condição aeróbia pela Superoxigenação (Página 2 do PDF (abre em nova aba)) |
| 3.000 mg/L | MLSS no tanque de aeração no exemplo (4200 lb de MLSS/MGD) (Página 2 do PDF (abre em nova aba)) |
Texto completo como publicado (em inglês)
O texto como seus autores o escreveram.
Wastewater Application: Clarifier Superoxygenation
Allow Clarifier to Operate as an Oxic Bioreactor
Does your WRF have process challenges?
…violations or consent decree?
…operating in the "red-zone"?
Common Process Challenges:
- Rising Sludge? …denitrification in the sludge blanket?
- Restricted by Capacity? …landlocked with no room for expansion?
- Need Lower F:M or Longer SRT? …insufficient BOD removal or nitrification?
- Difficulty Meeting Nutrient Limits? …winter changes or future permit?
Adding pure dissolved oxygen may be the solution.
The aerobic microbial sludge inventory can be increased up to 60% simply by superoxygenation of the influent to the secondary clarifier, allowing the sludge blanket to support aerobic metabolism throughout the settling process.
Aerobic Sludge Blanket in the Clarifier has the following benefits:
- Increased "solids under air" for a lower F:M ratio, and longer SRT
- Additional BOD removal for plants lacking physical space to expand
- Prevents rising sludge from denitrification in the sludge blanket
- Will not disturbing settling characteristics.
Wastewater superoxygenation is a process to dissolve pure oxygen to maintain oxic (or aerobic) conditions without disturbing quiescent settling conditions.
The level of dissolved oxygen (D.O.) required to support aerobic metabolism in a secondary clarifier is relative to its hydraulic retention time and oxygen uptake rate (HRT x OUR). Typical secondary clarifiers have a D.O. demand of 40 mg/L.
By using pure oxygen, 40-60 mg/L D.O. can be dissolved in the clarifier influent without exceeding the saturation level¹ ² ³. Thus, D.O. level of up to 60 mg/L will not cause effervescent loss of D.O. and will not change the settling characteristics. This makes secondary clarifier superoxygenation an ideal solution for plants facing certain operational challenges listed above.
The concept of Secondary Clarifier Superoxygenation is similar to the well-known principle of "Contact Stabilization" yet requires no additional tank volume. Both provide additional time for the bacteria to aerobically metabolize their internally-stored BOD before being recycled back to the aeration tanks. This ensures the RAS is "hungry" and therefore able to metabolize a new cycle of BOD when re-introduced into the plant flow. Superoxygenation allows this to occur inside the secondary clarifier, along with preventing rising sludge.
Notes on D.O. Saturation:
- The DO Saturation level with pure oxygen is 40 mg/L @ 0 ft head (STP)
- The DO Saturation level with pure oxygen is 60 mg/L @ 15 ft head
- The DO Saturation level with air is 8 mg/L @ 0 ft head (air=21% O₂)
Example: Anoxic Clarifier
The first diagram below shows a conventional secondary clarifier, where the entire mass of solids in the clarifier has zero D.O. content. During such conditions, these solids are unable to continue aerobic metabolization of BOD; and may be subject to denitrification which causes rising sludge. Maintaining a shallow sludge blanket, however, makes increasing MLSS and RAS concentration difficult to achieve.
Note: In the example below, the total mass of "solids under air" is equal to the solids in the aeration basin = 4,200 lbs / MGD.
Diagram: aeration basin at MLSS 3000 mg/L (4200 lbs MLSS/MGD), D.O. = 2 mg/L to the clarifier, RAS = 50% Q. Secondary clarifier: 750 gpd/ft², 5 ft deep sludge blanket, return sludge concentration 9000 mg/L, average MLSS in sludge blanket 6000 mg/L, 2500 lbs of solids/MGD, anoxic blanket.
Example: Oxic Clarifier (60% More Aerobic Biomass)
Alternatively, as shown in the diagram below, superoxygenation of the clarifier influent greatly increases the mass of "solids under air" – without additional tank volume, and without changing the settling characteristics.
Note: In the "Oxic Clarifier" example below, the total mass of solids under air equals A-Basin Solids + Sec. Clarifier Solids = (4200 + 2500) = 6,700 lbs / MGD. This is an increase of 60% more aerobic biomass.
Diagram: the same plant with a Speece Cone on the clarifier influent, D.O. = 40 mg/L, and an oxic 5 ft sludge blanket.
Food-for-thought: Without rising sludge in the clarifier, superoxygenation provides an opportunity to maintain a thicker sludge blanket and develop an even greater active biomass and higher sludge concentration.
Como citar
Uma linha para colar em um relatório.
Secondary Clarifier Superoxygenation to Increase Active Biomass and Stop Rising Sludge. ECO₂. Eco Oxygen Technologies Technical Library. https://eco2tech.com/technical-library/secondary-clarifier-superoxygenation-to-increase-active-biomass-and-stop-rising-sludge/
https://eco2tech.com/technical-library/secondary-clarifier-superoxygenation-to-increase-active-biomass-and-stop-rising-sludge/
O próximo passo
Pergunte a um engenheiro da ECO₂
Dúvidas sobre esta nota de aplicação ou sobre a sua água? Um engenheiro de aplicações responde, com os números.
